Description Model: M47120 50 Units in Stock
This jewellery case in Monogram canvas is the ideal refined travel accessory. It features 13 different-sized compartments and closes securely with an S-lock and two trunk latches.
13.39 x 10.24 x 3.94 inches (Length x Height...
Offshore helidecks 1.
This Offshore Information Sheet is to remind duty holders of the need to ensure that the testing of the quality of offshore helideck firefighting foam concentrates and mixing/induction systems are fit for purpose. It replaces Safety Notice 2/2004 which is withdrawn.2. Foam systems need to be tested in two louis vuitton alma multicolor ways, firstly by ensuring the system is in working order and secondly by analysing samples of foam concentrate and finished foam. The discharge of significant quantities of finished foam to the sea has potential to pollute the environment. Therefore the methodology for testing foam and equipment performance should be carried out with a view to minimising the potential for pollution to occur. 3. Systems should be tested and quality assured before installation to ensure that foam (particularly 1% inducted) meets its performance parameters. This would normally be done onshore, with the finished foam contained and suitably treated. 4. Routine periodic testing of performance in the offshore louis vuitton purses 2013 environment should be achieved by operating the equipment initially using water only and subsequently confirming by production of a limited amount of finished foam captured for testing. BS5306, NFPA11 etc.)5. This guidance is issued by the Health and Safety Executive. Following the guidance is not compulsory and you are free to take other action. But if you do follow the guidance you will normally be doing enough to comply with the law. Health and safety inspectors seek to secure compliance with the law and may refer to this guidance as illustrating good practiceTesting procedures for foam systems There are two tests of systems, a performance test when commissioned and an in service (annual) test. an "Acceptance Test") should be carried out: When the equipment is installed on a deck. When significant maintenance, refurbishment or component replacement has been undertaken that could effect a change in the foam quality or production performance of the foam making System. This includes a change of foam making branches, nozzles or monitors. Only louis vuitton shoes uae those parts of the system that could have been affected by the work undertaken or the component change need to be tested. The Foam Equipment Performance Test should confirm the following: The induction percentage for all foam making devices. The jet range of the monitor/s. The spray pattern of the main monitor/s. In Service (annual) test should be conducted to ensure the quality of the foam concentrate and the performance of the equipment. Samples of foam concentrate should be representative of the parent stock. A foam drum should be rolled or agitated to produce louis vuitton alma bag review a homogeneous mix before drawing a sample from the top. For bulk foam storage tanks circulate the contents to produce a homogeneous mix before taking a sample. Alternatively draw samples from the top, middle and base. Use a hollow tube to take a sample from the middle. For the base sample use a side exiting outlet pipe or alternatively run off about 25 litres of foam first to remove any accumulated sediment. This run off may be returned to the top of the tank. Several samples may be mixed equally to produce a single composite sample of 500ml.
A small amount of finished foam should also be collected by placing a sample collector in the discharge area. Sufficient finished foam should be collected to provide a 500ml sample of foam. This sample should be used to check the percentage concentration in the finished foam.
Prev: louis vuitton shoes in south africa
Next: louis vuitton shoes at saks